top of page

Need some help?

We are happy to assist you.

Please fill out the form below, and we will be back in touch to help you as soon as possible!

​

Upload File
Upload File

How to program a Liftmaster three-button remote:

  1. Take the four small screws out of the back of the receiver and remove the cover

  2. Make sure the chute is powered “on”

  3. In the receiver, press and release the blue button above the yellow wires. A yellow light will turn on.

  4. With the remote in hand, press and release any one of the three buttons you want to program until the yellow light turns off.

  5. At this point, the remote button is programmed, and can be tested.

  6. A successful test will trigger the solenoid.

  7. Repeat programming steps for each button on each remote.

  8. Replace the cover back onto the receiver, and clip back into place on the chute.

bottom of page